Cs2 4:3

[Daiz]

I am using dma with fuser set up and I prefer 4:3 in game which is different from my native resolution output on my second PC. Is this possible to have esp display correctly without having to mess about changing resolution on second PC? Sorry if this is a stupid question new to dma and the setup. 

[Luks]

On 7/16/2025 at 3:00 AM, Daiz said:

I am using dma with fuser set up and I prefer 4:3 in game which is different from my native resolution output on my second PC. Is this possible to have esp display correctly without having to mess about changing resolution on second PC? Sorry if this is a stupid question new to dma and the setup. 

Hey, not a stupid question at all — we’ve all been there when starting out with DMA and Fuser setups.

To answer you: yes, the resolution needs to be the same on both PCs — the one running your game and the second one doing the ESP overlay. If they don’t match, your ESP will be misaligned, stretched, or just not show correctly.

So even if you prefer 4:3 stretched in-game, you’ll need to make sure that both your main PC (with the Fuser) and your radar/second PC are set to the same resolution and refresh rate. It’s the only way for Fuser to overlay the ESP properly on your screen.

I know it’s a bit annoying to adjust, but once both outputs match, everything should line up perfectly and you won’t have to mess with it again.

Everything sent to the Fuser must be identical—same resolution, refresh rate, scaling—so it can perfectly layer the ESP output onto your main monitor without distortion.

[whosdaiz]

Yeah I had thought this would be the case but I play 768 res in game but outside of game it looks like **** and don't want to keep changing resolution on the fuser just to play. I think I will stick with 1080p on both to keep it simple . I really appreciate the reply thank you 

[Luks]

On 7/18/2025 at 1:22 PM, whosdaiz said:

and don't want to keep changing resolution on the fuser just to play.

It is what it is  That's a life on 4:3

Good luck in new season!